Hi, I had a hard landing today 
I bent the side arm of the zenmuse H3-3d. After an hour or so of taking it apart and bending the arm back to what seems straight, it seems to be "almost" working again.
I noticed the camera angle would never go vertical. I did a calibration and still no luck.
I was able to adjust with the gimbal limits and the rang of motion is good now.
The only thing I notice -the gopro is 1/16 inch lower on the left side of the phantom, so its not sitting flush. Is there some way to adjust this?
I bent the side arm of the zenmuse H3-3d. After an hour or so of taking it apart and bending the arm back to what seems straight, it seems to be "almost" working again.
I noticed the camera angle would never go vertical. I did a calibration and still no luck.
I was able to adjust with the gimbal limits and the rang of motion is good now.
The only thing I notice -the gopro is 1/16 inch lower on the left side of the phantom, so its not sitting flush. Is there some way to adjust this?
