Had a crash and as a result the ribbon cable detached from the camera. I had it replaced today and when I powered up the copter, the camera goes wild and cant settle into position. Any advice or recommendations is appreciated.
Any ideas .... Gimble going crazy
- Thread starter marcp
- Start date
Yes at least 3 times. The servo gets hot when it after a short time. The video is a short version of its erratic behavior.
I had the same problem with my p3s. I did nearly everything. I checked the boards, motors, alignment. I studied for 2 months and read and watched every U tube video I could find. I said I did nearly everything, except fix it. I bought a new gimbal. Let me know when you find out. I can sell it for more fixed. Good luck!
- Joined
- Jul 10, 2017
- Messages
- 563
- Reaction score
- 234
- Age
- 59
I saw something some time back about resetting the zero points for the gimbal motors required removing the cover near the little motors and aligning something ill see if I can fid that video. there are a bunch of videos here on the gimbal after a crash getting realignment
gimbal motor alignment phantom 3 - YouTube
gimbal motor alignment phantom 3 - YouTube
Wow r2d2 inside,try hold drone facing the ceiling and power on,might react differently
- Joined
- May 15, 2017
- Messages
- 53
- Reaction score
- 13
- Age
- 34
I had a problem similar to this. There was a set screw loose on the gimbal somewhere
- Joined
- Jul 10, 2017
- Messages
- 563
- Reaction score
- 234
- Age
- 59
- Joined
- Oct 9, 2017
- Messages
- 5
- Reaction score
- 1
- Age
- 56
The set screw on the gimbal arm is loose. It's trying to adjust and center, but it keeps moving and can't. Easy fix. ---
- Joined
- Oct 9, 2017
- Messages
- 5
- Reaction score
- 1
- Age
- 56
Similar threads
