- Joined
- Feb 23, 2016
- Messages
- 254
- Reaction score
- 42
- Age
- 85
I flew my Stock P3S with FW 1.5.7+ and its associated Go App (2.8.2 I think) and got 1213 m. Did screen capture after signal regained.
I then upgraded to Go App 2.8.4 and drone FW 1.6.8. I could only fly around 850 m.
Next I downloaded FW 1.5.7+ on my desktop from the site Phantomhelp.com. I put the FW on the P3S drone microcard,
not in a folder and without any other FW version, then put card in bird. With everything turned off, I depressed the link button and turned only the drone on. When noise changes, release button and wait until light on camera front turns green. This process is described elsewhere on the P3/4K site. My flight results are shown below.
Again, Go App 2.8.4 and FW 1.5.7+ with stock P3S.
Sent from my iPad using PhantomPilots mobile app

I then upgraded to Go App 2.8.4 and drone FW 1.6.8. I could only fly around 850 m.
Next I downloaded FW 1.5.7+ on my desktop from the site Phantomhelp.com. I put the FW on the P3S drone microcard,
not in a folder and without any other FW version, then put card in bird. With everything turned off, I depressed the link button and turned only the drone on. When noise changes, release button and wait until light on camera front turns green. This process is described elsewhere on the P3/4K site. My flight results are shown below.

Again, Go App 2.8.4 and FW 1.5.7+ with stock P3S.
Sent from my iPad using PhantomPilots mobile app
Last edited: