Hello,
After looking for a solution on this website, I decided to post my problem.
My problem is with my gimbal top board P01069.10 of my Phantom 3 advanced.
the LED stay off when I turn on the drone.
The voltages on the board are OK exept : 1V2, VCC3V3 and VCC1V8 who stay at 0V (maybe only for phantom 3 pro?)
When I use Putty on U0_T and GND, I can see "Cortex Boot-Up success" in loop.
From what I saw on this website, the problem would come from Ambarella chip.
Can you help me to resolve this problem?
Thinks.
After looking for a solution on this website, I decided to post my problem.
My problem is with my gimbal top board P01069.10 of my Phantom 3 advanced.
the LED stay off when I turn on the drone.
The voltages on the board are OK exept : 1V2, VCC3V3 and VCC1V8 who stay at 0V (maybe only for phantom 3 pro?)
When I use Putty on U0_T and GND, I can see "Cortex Boot-Up success" in loop.
From what I saw on this website, the problem would come from Ambarella chip.
Can you help me to resolve this problem?
Thinks.
