- Joined
- Jun 17, 2015
- Messages
- 56
- Reaction score
- 23
- Age
- 43
So.. in December I had a brainfart while flying one of my birds and didn't check my route well enough while flying backwards... and lights out, caught a tree, battery ejected, feed went black, etc.
I had last known GPS and searched for hours, but it was in 3 ft of fresh powder in the mountains, and since my P3P went silent at about 100 ft up and 35 mph, there was a reasonable search radius it could have ended up.
Long story short, I went on a retrieval mission last week and found it. From where it was (a WELL searched spot) and how it was sitting, I think it was caught in one of the trees and fell out at some point during the winter.
Here she is after spending about 5 months in nasty winter conditions, snow, rain, melt, etc. None of the props were damaged, gimbal, camera, all fine. Just a bit dirty, and a few screws were a bit rusty! Took her home, SD card is perfectly fine, the motors had some rust so they needed to be swapped (only 3 actually). I was worried the motherboard/internals would have rust, but none that I can spot.
I have to say I was pretty surprised, I thought I could salvage some bits and pieces and do a re-build, but so far she's good as new!
Not really much to discuss, just thought I'd share...
I had last known GPS and searched for hours, but it was in 3 ft of fresh powder in the mountains, and since my P3P went silent at about 100 ft up and 35 mph, there was a reasonable search radius it could have ended up.
Long story short, I went on a retrieval mission last week and found it. From where it was (a WELL searched spot) and how it was sitting, I think it was caught in one of the trees and fell out at some point during the winter.
Here she is after spending about 5 months in nasty winter conditions, snow, rain, melt, etc. None of the props were damaged, gimbal, camera, all fine. Just a bit dirty, and a few screws were a bit rusty! Took her home, SD card is perfectly fine, the motors had some rust so they needed to be swapped (only 3 actually). I was worried the motherboard/internals would have rust, but none that I can spot.
I have to say I was pretty surprised, I thought I could salvage some bits and pieces and do a re-build, but so far she's good as new!
Not really much to discuss, just thought I'd share...

Attachments
Last edited: