Need P3 pro upper gimble.

[BuckRogers]

Where the cable inserts on mine, the connector came loose. So I need this for the pro. If you have a scrapped camera, would help me out

 

[BuckRogers]

Piece in lower right

 

[Sinisalo]

Where the cable inserts on mine, the connector came loose. So I need this for the pro. If you have a scrapped camera, would help me out

you could try to do a re-flow. If it is broken already I would say it is worth a try. I fixed an iphone with this method that had one of the connectors come loose of the mainboard.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[bobmyers]

Check with @hunch-- he may have that piece.

 

[DEllis]

Have this

 

[Sinisalo]

After Thinking it over in the shower I believe instead of using the oven method to re-flow the solder, you should use a heat gun and thick aluminum foil with a small spot cut out for the area you need the solder to re-flow at. Start out conservative so you don't melt anything other than solder and then wait for it to cool and see if it worked if not try heating it a little longer.

 

[hunch]

Check with @hunch-- he may have that piece.

yup, i have several if needed.