My DJI Phantom 4 is getting a "Transmission Image Lost" message. Also, "Processor is critically over heating" message. What is wrong?
My DJI Phantom 4 is getting a "Transmission Image Lost" message. Also, "Processor is critically over heating" message. What is wrong?
- Thread starter Jim Hampton
- Start date
Many devices (incl my iPad mini) overheat especially in direct sun. Get out of the heat or the device will shut down. You should still retain control vlos. Or RTH.
The cpu may also be overworked by other apps running in the background. Always try to shutdown unused apps while flying.
The cpu may also be overworked by other apps running in the background. Always try to shutdown unused apps while flying.
Yip try airplane mode,,uumm just to be clear are you getting this from your tablet or drone,what the status of aircraft on start up,,I ask this because after a p4 I had freefalled to its death when I powered that back up it had that prompt aswell and that part inside drone was very hot,it was that big alloy part what ever that processor called,hopefully it's not what I show and is tablet overheating
Attachments
This could be a bad fan on the camera. Can you hear it come on?
It's the drone processor. When I take the battery out I can feel the heat on each side of the battery enclosure. I don't hear a fan turning on. On start up, it's ok. After about 3 minutes flight time I get these messages. the big allow thing is the heat sink.
You might have to drop gimble assembly which is pretty easy to do and check if fan stuck or needs new one,,might have unplugged a bit from the board,
Similar threads
