Gimble issue

[sajindra]

Hii guys, there is an issue with my aircraft's gimble. When I turn on the unit gimble acts weirdly. I always have to restart the drone. Some time I have to give a little push to calibrate the gimble otherwise no image transmission kicks out. Never crashed before. I ll upload two videos. Hope you guys ll suggest me a solution. Thank you in advance. ))

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

Please check the below video.(usually, after the restart gimble acts normally. But sometimes not. I have to restart again. However this time it acted normally

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[ppetros]

Hello. I have the same issue with the last firmware. I try to put lens to gimble (the P3 was off) and then when i power up there was this issue.
When i start the P3 with a new inserted battery the problem occurs.
After that gimble start to work (even with some help) and try on/off again when i don't eject the battery everything is ok. As long i eject it and leave it some time and re-inserted, i have the problems...
Any solution?