Gimbal Problem

[apsnboy]

After replacing the yaw motor, the gimbal is only in this position!

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[AbqDroner]

Have you done a full calibration through the app?

 

[apsnboy]

Have you done a full calibration through the app?

yes, i did full calibration IMU and Auto Calibrate Gimbal.

 

[amstar]

yes, i did full calibration IMU and Auto Calibrate Gimbal.

Manually rotate the gimbal to the right until you feel a local or click. Then do a gimbal calibration.

 

[Droneted]

Did u use the original yaw casing and just replace the windings?

 

[Droneted]

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[jiminyfixit]

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

Ted is the man!!! This issue has been addressed in previous posts by Ted and myself. I'm not sharp enough to give you the exact link, but the discussion is extensive and worth the read, if you can locate it. Be sure to SAVE THE OLD MOTOR. Ted and I are perfecting a way to replace the sensor/s, since the only motors available on eBay are NOT new and may have a damaged sensor. The motors are the same for the old and new version drum.

Cheers,
Jim