Check out his battery charger organizer...I have one of those on order...I'm getting my P3P totally geek'd out
:h
DIY Antenna Booster for Phantom 3
- Thread starter PVFlyer
- Start date
:h
- Joined
- Jul 10, 2015
- Messages
- 54
- Reaction score
- 3
- Age
- 55
How?? Because I cant either.
Am thinking of getting another P3 just to see if I get more range from a stock unit
It really can the furthest ive gone was 3000ft and i didn't have the balls as yet to continue so i flew back... Also considering the environment with lots of trees and buildings and a railway which has lots of interference and fly at 20m which is low.
The Furthest I'v gotten on LOS (River , Flat marsh's , no house's or power lines ) is 3200'.I turn around when weak signal shows up in red
I'm hoping sooner or later someone can point me in the right direction
10967 feet before the latest firmware, now barely 5k feet.. Hoping this will help get me back in the 10k range. Really wish someone would figure out how to get our video channels back.
Just got back from using David's 3d printed booster. I can confirm 100% this works great. I normally get 1,800 or 1,900 feet out before I get a weak signal when I fly in the city. Tonight I got 3,068 feet.
I was worried that it would make the signal too focused but I didn't find that to be a problem at all.
The only slight issue I have with the device is I have to apply more pressure than I would like to the antennas to get them to snap in place. I'm extremely careful with most of my belongs so this is probably just me. If he made it much looser - they probably wouldn't hold.
Overall, I'm extremely happy. Thanks David!
I was worried that it would make the signal too focused but I didn't find that to be a problem at all.
The only slight issue I have with the device is I have to apply more pressure than I would like to the antennas to get them to snap in place. I'm extremely careful with most of my belongs so this is probably just me. If he made it much looser - they probably wouldn't hold.
Overall, I'm extremely happy. Thanks David!
My antennas snap in place firmly...Try holding the antenna right above the keeper and gently rotating the antenna until one edge clears one side of the keeper and it pops right off with less strain.
:harry
- Joined
- Apr 21, 2015
- Messages
- 99
- Reaction score
- 23
This booster looks great, people seem happy, and the results speak for themselves. I have one question though... it's recommended for the antenna to be in somewhat of a "V" formation, whereas the booster (as far as I can tell) locks then into a parallel orientation. Has any testing been done with printing the parabolas to allow for the "V" formation? If yes, what impact did this have on performance?
No, it's NOT recommended to be in a V position. Parallel as shown is the correct position.
I did a range test the other day and was shy of 1 mile. I had total control, just turned back a tad to soon. This was done on stock set up.
I ordered Dynamic 3d Solution's windsurfer. Hope to compare and see if there is any gains.
I ordered Dynamic 3d Solution's windsurfer. Hope to compare and see if there is any gains.
Yes the booster does work great. Normally I get ~3000ft. After installing the booster, I got ~8000ft. Real crazy.
Personally, I prefer slight "V" (<20 degrees vs. vertical) antenna setup to keep antennas slightly apart for lowering interference and improving diversity gain.
Similar threads
