This is my first message on this board so hi everyone!
I recently received a second hand P1.
It was working fine until TX could no longer bind with RX (symptom : led on P1 constantly flashing yellow).
I opened the remote and noticed the antenna wire was broken
How can I fix this? It's broken quite close to the bottom of the antenna. Any chance to re-attach the two parts? I cannot find a replacement antenna anywhere
Important note : the remote is the SR6 edition. It comes with the old circuit. This means the antenna is soldered to the circuit. Not as easy as buying a U.FL to RP-SMA pigtail cable and doing the classic TX mod.
Thank you.
Best regards,
I recently received a second hand P1.
It was working fine until TX could no longer bind with RX (symptom : led on P1 constantly flashing yellow).
I opened the remote and noticed the antenna wire was broken
How can I fix this? It's broken quite close to the bottom of the antenna. Any chance to re-attach the two parts? I cannot find a replacement antenna anywhere
Important note : the remote is the SR6 edition. It comes with the old circuit. This means the antenna is soldered to the circuit. Not as easy as buying a U.FL to RP-SMA pigtail cable and doing the classic TX mod.
Thank you.
Best regards,
Last edited:
