I couple weeks back I had a pretty bad crash with my P1. I found it the next day upside down in the snow but luckily when I got it home and took it apart all 4 motors still started up.. Being new to dji products I made a noob mistake and after taking off the broken parts of the prop guards I put the screws back in.. When I started it up next 3/4 motors twitched I eventually got that down to only one twitching without replacing anything but decided I needed to replace all 4 motors which I recently did.. I also ordered 4 new esc's just in case and have replaced two of the old ones at this point.. Now all 4 motors start up and idle perfect but when I go to lift off it tips over every time, the only way I can get it in the air is to adjust with right stick and even then it is super sketchy doing and I have minimum control over it and I am almost completely unable to yaw, it just drifts all over.. After doing countless IMU calibrations using sheets of paper to get it perfectly level plus a sheet of glass over the motors to make sure they are level it will will not fly right at all and at this point I am stumped.. I ordered new stock dji props so that's not the problem either.. Sometimes it does appear motor #2 May be spinning just slightly slower than the rest but won't have a way to tell until the tachometer I ordered arrives but I really don't think that'd be it considering it's a new motor and correct me
If im wrong but wouldn't naza make up for that? It still connects to sattalites fine and if I do get it in the air it has hovered fine but has also done some other strange things right after.. It is not safe to fly. I have a few extra motors and esc's but don't see what changing another motor would do when all 4 are brand new and if one ESC was bad it wouldnt start that motor anyways as far as I know! If anyone has any input it would be greatly appreciated! I almost pulled the trigger and upgraded but decided if I can get this thing in the air on my own im not ready for an upgrade..
If im wrong but wouldn't naza make up for that? It still connects to sattalites fine and if I do get it in the air it has hovered fine but has also done some other strange things right after.. It is not safe to fly. I have a few extra motors and esc's but don't see what changing another motor would do when all 4 are brand new and if one ESC was bad it wouldnt start that motor anyways as far as I know! If anyone has any input it would be greatly appreciated! I almost pulled the trigger and upgraded but decided if I can get this thing in the air on my own im not ready for an upgrade..
