I have a Phantom 1 Drone that I am trying to repair for a school project. When I received the nonfunctioning drone, I was told that it was sold because the previous owner removed the propeller guards, but put the same screws back in(which were longer than the originals because of the guard) and screwed right into the motors. I have since replaced all four motors, and in doing so dealt with a plethora of error codes. The one the I'm stuck on is a flashing yellow and ten three red flashes. Although I guess it could be three red flashes and then one yellow. According to the Led Descriptions (see attached), it means GPA signal <5 Atti. What does this mean? How do I fix it?
I called the tech support line and they told me to recalibrated the compass. I did this, and nothing changed. I called back and they said to connected it to the NAZAM DJI Assistant on a computer and check the IMU Status and Reset the BTU info. I did this too and nothing changed. I also advanced calibrated it. I called the support line again, and they said there was nothing they could do. Please help me. I've never dealt with drones until now, and I just wanna pass this class.
I called the tech support line and they told me to recalibrated the compass. I did this, and nothing changed. I called back and they said to connected it to the NAZAM DJI Assistant on a computer and check the IMU Status and Reset the BTU info. I did this too and nothing changed. I also advanced calibrated it. I called the support line again, and they said there was nothing they could do. Please help me. I've never dealt with drones until now, and I just wanna pass this class.
