- Joined
- Oct 19, 2016
- Messages
- 154
- Reaction score
- 54
P4P; iPad Pro
Firmware (Aircraft): see below
Firmware (Controller): see below
Just last week, when using DJI Go4, the Max Flight Altitude started getting stuck at "0", my C1/C2 buttons which had customized settings now read "Not Defined", and "Multiple Flight Modes" became disabled. I tried typing in "120" and tapping "complete" for the MFA, but it won't stick. My Firmware at the time was current. Since then, a new firmware came out and I upgraded, but the same thing occurs. Also, set it to "Restore Factory Defaults". Today, I reconnected the RC, but that didn't help.
Only when I shut everything down (Aircraft/Controller/DJI Go4) does the MFA reappear. While the aircraft and RC are still on and I close and reopen the app, the MFA reverts back to "0", and I'm forced to shut everything down again and restart the entire sequence to make "120" appear again for the MFA.
I also performed a "Check for Updates" on my iPad and there was no indication updates were required. When doing that, the pause wheel just spun for a few seconds and then stopped and no notification was seen. I assume that means no updates were required.
Here's the kicker >>> the serial number on the bottom of the RC and the serial number seen in the DJI go 4 app are different!! The s/n on the bottom of the RC starts with "OCLJ" and the RC s/n displayed in the DJI Go 4 app starts with "OCKJ". (????????????). The Aircraft and RC have never been separated since I took them out the box on Day 1 and have never given any indication of trouble until last week. I also reset the controller multiple times (C1+C2+Red Image button). It usually works just once then reverts to 0 MFA again. Any suggestions??
Firmware (Aircraft): see below
Firmware (Controller): see below
Just last week, when using DJI Go4, the Max Flight Altitude started getting stuck at "0", my C1/C2 buttons which had customized settings now read "Not Defined", and "Multiple Flight Modes" became disabled. I tried typing in "120" and tapping "complete" for the MFA, but it won't stick. My Firmware at the time was current. Since then, a new firmware came out and I upgraded, but the same thing occurs. Also, set it to "Restore Factory Defaults". Today, I reconnected the RC, but that didn't help.
Only when I shut everything down (Aircraft/Controller/DJI Go4) does the MFA reappear. While the aircraft and RC are still on and I close and reopen the app, the MFA reverts back to "0", and I'm forced to shut everything down again and restart the entire sequence to make "120" appear again for the MFA.
I also performed a "Check for Updates" on my iPad and there was no indication updates were required. When doing that, the pause wheel just spun for a few seconds and then stopped and no notification was seen. I assume that means no updates were required.
Here's the kicker >>> the serial number on the bottom of the RC and the serial number seen in the DJI go 4 app are different!! The s/n on the bottom of the RC starts with "OCLJ" and the RC s/n displayed in the DJI Go 4 app starts with "OCKJ". (????????????). The Aircraft and RC have never been separated since I took them out the box on Day 1 and have never given any indication of trouble until last week. I also reset the controller multiple times (C1+C2+Red Image button). It usually works just once then reverts to 0 MFA again. Any suggestions??
