P3 Advanced Limp Gimbal:(

[efrancanojr]

Hey everybody, I need some help with some thing. I was getting the gimbal overload error for a few days and now my gimbal is completely unresponsive. Camera works fine but there is no movement or noise or anything from there gimbal. Any ideas?

 

[DoomMeister]

You can post a forum welcome here, but replies to the gimbal problem should be posted here

Phantom 3 Advanced Gimbal Kaput:(

Hey, all so for a few days, I was getting the gimbal overload error message and now my gimbal is completely dead. Camera works fine. Will not respond. No noise no movement no anything. Please help!

phantompilots.com

 

[RodPad]

You can post a forum welcome here, but replies to the gimbal problem should be posted here

Phantom 3 Advanced Gimbal Kaput:(

Hey, all so for a few days, I was getting the gimbal overload error message and now my gimbal is completely dead. Camera works fine. Will not respond. No noise no movement no anything. Please help!

phantompilots.com

Thanks!, you made my DAY!!
Rod

 

[Johnnydiesel]

Hey everybody, I need some help with some thing. I was getting the gimbal overload error for a few days and now my gimbal is completely unresponsive. Camera works fine but there is no movement or noise or anything from there gimbal. Any ideas?

Sounds like your gimbal motor bud. Look for droneted here. He is very good with these issues.

 

[RodPad]

Johnnydiesel

phantompilots.com

Thanks!

 

[efrancanojr]

OK guys I got my gimbal pitch motor installed and put everything back together but now I’m getting gimbal disconnected error. What did I get myself into!

 

[KachemakDiver]

Did you replace the old black flat cable with a OEM one?

 

[RodPad]

You can do a continuity test on the flat ribbon cable.

Rod

 

[efrancanojr]

Oh no sir I kept same cable. Should I have replaced that?

 

[RodPad]

Check this thread out.
It is based on a P3S.

P3S live camera feed but gimbal is dead

I have live camera feed but the gimbal is dead. I purchased the P3S 2nd hand and had only been flying about 3 months when i'm not real sure what happened but it was about 50 ft off the ground and just tumbled down. when i picked it up the camera and the arm holding it onto the gimbal had...

phantompilots.com

Rod..

 

[KachemakDiver]

Oh no sir I kept same cable. Should I have replaced that?

That is correct. Try for a OEM one