Help Terrible Vibration

[Mike2015]

My drone footage is terribly shaky. I have a Zenmuse H3-3D carrying a GoPro 4 Silver.

I have

1. removed the White dampeners and replaced them with the Black 40 ones.

2. Balanced props

3. Fitted an ND filter

4. Adjusted gain settings.

When I hover the gimbal is shaking terribly. Can anyone help.

Basic

Pitch. 125%
Roll. 125%
Yaw. 120
Vertical. 140

Attitude

Pitch. 260
Roll. 260




Sent from my iPad using PhantomPilots mobile app

 

[jason]

My drone footage is terribly shaky. I have a Zenmuse H3-3D carrying a GoPro 4 Silver.

I have

1. removed the White dampeners and replaced them with the Black 40 ones.

2. Balanced props

3. Fitted an ND filter

4. Adjusted gain settings.

When I hover the gimbal is shaking terribly. Can anyone help.

Basic

Pitch. 125%
Roll. 125%
Yaw. 120
Vertical. 140

Attitude

Pitch. 260
Roll. 260




Sent from my iPad using PhantomPilots mobile app

Have you been using that ND filter with the white damper as well?

Some here will advocate adjusting the gains I'm not in favor of doing that. By increasing gains will also increase the reaction time and decreasing the gains will do just the opposite.

 

[Mike2015]

I have not tried the White dampeners with the ND filter. Should I try the White dampeners ? I did find the grey dampeners were too stiff.

 

[jason]

I have not tried the White dampeners with the ND filter. Should I try the White dampeners ? I did find the grey dampeners were too stiff.

Put the white ones back on and take that ND filter off and put the gains back to default. Have you tried a gimbal hard reset ?
I know it says reset for a H3-3D gimbal and H4-3D is basicly the same gimbal and this video will show you how's done.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

Also make sure the gimbal configuration setting are to 50 ,0 and 0 and you'll fine those in trhe P2's software in the advanced tab and FPV mode unchecked.

 

[Sandris]

Hmm, I just got 4 new props for my p2, and after inspecting I realize, that two of them are bent. Maybe this can cause your vibration?
Also a question, how to fix a bent prop?

 

[jason]

Hmm, I just got 4 new props for my p2, and after inspecting I realize, that two of them are bent. Maybe this can cause your vibration?
Also a question, how to fix a bent prop?

Were those after market props or OEM replacements?? Sounds like after market had a bad prop from dji stock.

 

[jackyrrab]

Try the hidden screw at the top of the gimbal arm. Need to get a really small Allen wrench and tighten it up