After a recent accident the gimbal flat wire needed replaced. After replacing it everything seems to turn on fine but the camera controls are messed up. Not only is the camera at a tilt but now when I move the camera wheel that's supposed to pitch the camera the yaw motor wants to move. My thoughts are bad wire or I didn't get one of the connections in completely? I did do a complete teardown of my Phantom and painted the shell. Now it wants a firmware update even though I just updated it last week. Any suggestions?
Camera yaws when I move pitch control
- Thread starter wakesmith3
- Start date
-
- Tags
- flat wire gimbal control pitch roll yaw
Did you calibrate IMU and gimbal after repair? There have been two updates recently. Maybe it's looking the the newest one?
I don't know for sure. But worth a try. I think IMU calibration is recommended after alterations or a crash and repair.
Then do gimbal calibration.
Here are some instruction videos.
Phantom 3 Series - YouTube
Then do gimbal calibration.
Here are some instruction videos.
Phantom 3 Series - YouTube
Similar threads
