Recent content by xitake

Byroman, Thanks for the detailed description! I will follow your advice and wait to test this app whenever I get the chance to be in the fields. I'm also concerned about the landing process, as I had bad experience with tipping over in the past and since then I hand-catch the Phantom when I...

I'll test this amazing app to map my house. However, first I'd like to check with you what happens once you hit "Start mission". Will the phantom take off and go mainly vertical until it reaches 50 meters and then after this start moving through the mapping path? I'm asking this because I don't...

Re: DJI has released the new firmware v3.08 for Phantom 2 se Is it possible to downgrade to 1.08 from 3.6? Has anyone tried this yet?

Re: How to manually increase the txpower of PV2 for more ran Yes, you're right. In the status section I see 20 dBm. So how can I change it to 27 dBm? Even after I apply to 27 dBm it shows in the status pane as 20 dBm.

Re: How to manually increase the txpower of PV2 for more ran Very nice instructions! I tested it and it boosts my range from 350m to 420m. I would expect more, considering that this mod will increase the TX power from 100 mW to 500 mW. One thing that I noticed is that in the webUI of the...

I'm very interested to buy this set of glasses! I live in Brazil and the customs clearence here can take up to 45 days. I will be at Switzerland from May 18th to 25th and I'm thinking about buying these glasses and inform them to ship to my hotel in Bern. How long did it take from the moment...

Yes, it does work as it should. I can have signal of up to 12 sattelites at Curitiba.

Thank you for the suggestion! I've watched some videos of those screw extractors and they really seems to work. However, this screw that I stripped is attached to a PCI board and also it is too small (PH00). Do you think this could still work? Thanks!

Hello! Today I tried to open my P2V camera in order to mod the antennas, but I failed miserably. When I attempted to remove the 2 screws that holds the camera sensor+lens (please see image below), I accidentally stripped (damaged) one of the screws, and now I can't removed it as the screwdriver...

I could only found it being sold at Drone Fly (http://www.dronefly.com/ProductDetails. ... e-extender) and it's out of stock at the moment. Does anyone know where I can buy it? Thanks!

Could you figure this out? I have the exact same problem: after I drilled a hole on the repeater, the system LED won't blink or light at all and the wifi network is not listed any longer :cry: