Recent content by xerocomus

Shorting the path to GND solved the issue. Thank you.

Dear guys, My lightbridge 1 got broken again. I did the whole procedure on my lightbridge 1. I got the "operation success" message. Weird thing now is that even if bsel and 3v3 are disconnected, I keep getting the "bootme" message on tera term. It looks as if the board was stuck in the...

Seems I have an interesting problem. Gorpo connected to HDMI screen : it works Gopro connected to lightbridge via AV: it works Computer connected to lightbridge HDMI: it works, lightbridge transmits what it on my computer's screen Gopro connected to lightbridge via HDMI: does not work Same but...

I tried to short bsel with the pin right next to it instead of the 3v3 suggested at the beggining of this thread. It worked. My lightbridge is now working again - thanks to those who developed this solution.

Dear all, Unfortunately I ripped off the 3.3v soldering pad on air unit. Is there another place on the board were I could access the 3.3v? I don't see any. (I was pulling on my solder joint to assess its quality) Thanks M.

Dear all My lightbridge 1 has the problem discussed in this thread. I do not have the time to repair it by myself. If anyone here would be interested to try repair in exchange of some money (to be arranged), please let me know. Have fun M.

Hello Anyone here tried to use the snail with a Naze32 ? I managed to have it almost wobble-free. Except when I give it a strong pitch or roll kick it wobbles like crazy and usualy crashes itself. The P value is as low as can be, if I get any lower it becomes sluggish. I tried to lower the I...

So I bought an additional 2.4 ghz circular wireless helical and one 3w sunhans amp. New setup Remote : two circular wireless helical antennas ( 11Dbi according to manufacturer). Quadcopter : two circularly polarised omnis + one sunhans 3W amp. I did a quick test flight over the woods...

Hello, I'd like to extract one channel from the lightbridge d-bus and use it to controll an electronic switch. Switch : Turnigy Receiver Controlled Switch According to the lightbridge software assistant, channel 8 is available. Would this be possible with this decoder : FrSky 4-Channel S.BUS...

Ok so I won't be buying new amps for now as - appearently - the problems come from the fact that I have a lot of wifi around me. What about some circularly polarised antennas ? Two helicals on the remote and two omni antennas on the drone. If I'm not mistaken they could help reject noise...

A pannel antenna like the DBS one ? I've considered getting one, it's quite bulky though. And I still have the helical antenna I was using with my analogue system ( would need to buy a another one). But I'm not sure I understood your explanation of why it's a bad idea to use amplifiers ...

I've been using a UHF control link and 2.4 ghz analog video link coupled with cp antennas for the past two years. The range was nice, about 5 kms with omnidirectional antennas. However, I wanted an HD video feed, and got a lightbridge for about 700 $ ( sure it's expensive for what it is). So...

Hello all I bought a lightbridge for my naza drone a couple of months ago. Because of poor range, I installed two hobbyking 2W amps on ground unit : things got worse, video got pixellated even at close range. The best configuration I found is to have one amp on air unit : gives about 1.5 kms...