Recent content by tommi.piiroinen

Seems like you are using dji go 4? P3-4K uses dji go version 3(before phantom 4).

Hello all! I want just to check that I have done everything correct. Here is 2 screenshots of telnet. 192.168.1 (RC) and another is 192.168.1.2 (AC) I'm good to go(fcc)?? I live in CE area. Doesn't that "country US: DFS-FCC" mean that it uses FCC power to 5.8 GHz also?

I'm currently using MP on my p3-4k. Firmware version is v.1.5.40. I noticed that there is firmware upgrade available (v.1.6.40). Is MP working with that new firmware?? Is that new firmware working better than older? I don't want to upgrade the firmware if it doesnt cause it probably would reset...

It is.. My galaxy s7 works ok. Litchi tracking is prosessed on phone so that is why it takes so powerfull device to work..

I can't find this warning anymore in litchi help page?? Is it fixed?

I can't find this warning anymore from litchi help page. Is it fixed and RTH will work on all flying modes?

Dji go doesn't support active track on p3-4k. Its based on gps tracking. Litchi will support this active track with camera tracking but requires high end device. Max speed is 30kph.

There is where I found this guide to changing these two files.. I have tried to open dji go v.3.0.1 several times today with the internet connection enabled and it doesn't show that annoying update screen.. Hopefully it doesn't show it never again.. I would go with litchi but even I fly with...

I copyed those two files to my pc and deleted those few rows from both files and saved them as read only files. Then I copyed them back to dji.pilot cache folder and still cannot get it to work... What I'm missing here :/ I know that editing hosts file might do the trick, but my phone isn't...

Yes galaxy s7..

I don't mind so much about here maps, but the video lag is terrible in 3.1.3

..and with those settings I have DJI Go doesn't have internet connection at all. There are lots of pending connections to accept or deny. Shouldn't it connect everything else than that upgrade address?? Here is a list of connections:

I can't get 3.0.1 working anymore?? What I'm missing here?

It is not flying software related. It works with all flying softwares..

I had them right.. I understand that female to female, but male to male? Isn't that impossible because of the pins?