Recent content by theoneandonlybrooks

Thanks. Is it possible to plug a phone or tablet into the controller to run Dronedeploy?

iPhone pics are probably fine.

How much has it been used? Anything else come with it?

Any pics of the drone and controller?

The DATcon instructions are just what I was looking for. Thanks.

Did you use one of those readers to pull the logs or is there a simple way to get them?

Has anyone pulled flight logs to geotag images from a second onboard camera? Any good recommendations or articles on how to do it? I purchased an NDVI camera and am thinking about mounting it to my P3P but it doesn't have onboard gps so I need to use the logs to geotag the pics.

Thanks for the feedback. Flew it today in windspeeds from upper teens to upper 20's. Turned off the vps, landed much better despite the wind. I was landing with some trees for a bit of a wind break, similar to where I was struggling the other day. I was also testing out an NDVI camera on my...

I have no complaints with my rth landing accuracy. It's the manual landing that I'm struggling with on this drone.

I don't think any of mine would hit the pad on rth, but I have no problem manually landing the others in that small of a circle (24"). I know the Evo is newer, but the Solo lands just as well as it. The P3P just shoots around when trying to manually land. Your comment does remind me that I flew...

Ok, I will try that. Thanks

Maybe this is normal, but this is my first DJI drone so I don't know. My used P3P is very squirrelly at low altitude, like a couple feet off the ground, it is not stable in ground effect. 10 feet off the ground, a little better, 20 feet up, pretty stable. I have a 24" landing pad, and it's rare...

What about brand new batteries still in the box? Is it ok to keep them in the box or should I take them out and charge them so they can discharge?

Those look a little more serious

That's the same backpack I have. How much did you have to take out? I haven't started but was hoping maybe an 1/8 inch or so. I don't have a heat knife so I may just try a utility knife.