Recent content by Skyfly101

Ok than you for the advice

Vps cuts out at 9.6 feet or something I believe so 10 feet is the bare minimum you want to be flying with vps on over water or else the drone might drop due to not knowing it's surroundings. I personally turn it off whenever I plan on flying over water

Recently I have been flying my phantom and noticed a lot of birds being attracted to it even a have a couple video of birds chasing the drone. I have been trying to find a way to avoid the birds at best or to shake em off. I normally land the second birds start getting a little crazy but I worry...

To flash go to camera settings or the one with the drone on it and then go to advanced settings and look for flash sd

Make sure you back anything up you want to keep on your computer. Flashing deleted everything on the 1st card

Have you tried a new ad card or flashing the one that came with the drone. In case you didn't know you have to use a card 64 gb or under and it has to be a uhs-1 and a 10 class. This worked for me. Are you still getting the live feed?

Then go home find the flatters spot whether it's your floor table sidewalk whatever and calibrate imu. Then gimbal. Then controller. And that should help

I actually seemed to fix it through my numerous trial and error. And calibrating everything and trying new spots to calibrate and I found once you calibrate you really don't to do it again until you see error. And since I haven't. Next time you calibrate your drone go to an open field and put...

Yes the problems are gone I spoke with a dji employee and they said it was the ad card and sure enough a new ad card fixed it. Thanks for the help

And it was in the fridge not the freezer. My state isn't very humid at all. So humid is not a problem

Lol that's his fault for forgetting it in the freezer.mine was in their for 5 minutes. I have flown it since and it works fine.

Too late. Lol it actually works well I only had it in for 5 minutes. I love where it is normally 115 degrees Fahrenheit out but thanks to storms it cooled the weather done so I was able to fly I'm the morning and at night. But the imu has to reach temperature and just sitting outside for more...

Yeah I can see your point. They have lots of pros and cons and can be useful or unuseful to certain people

To be advised. I use a hair dryer on cool setting or a desk top fan to blow air on drone when updating just to be known it helps keep the drone cool and updates better. Espeacially when not flying the phantom but it is powered on for a long time

1.Are you trying to connect via Wi-Fi 2.What Wi-Fi is showing up when you turn the remote on ( the standard might overheat if you leave it on too long while starting up so turn it off You don't need it to connect to he Wi-Fi just the remote. 3.do you know the password?