Recent content by rishu.asthana

Battery switch mounted on ultrasonic sensor board . U can jumper it and use it . Sharing pic for reference

Hi I thanks for the reply . I have replaced the fc and it is working fine now . Thanks everyone for helping me .

??? Then what you stated above in comment "proper test equipment " Brother if you dont have knowledge then why are you misleading me After reading your comment i spent almost an hour on searching a test equipment for flight controllers on internet .

Pl Please let me know about the test equipment you mentioned in above comment for flight controllers And where can i buy that.

I have another fc and will check tomorrow .

I removed the tape and inspected that edge of ic carefully but didnt find any damage. Even checked the other side of fc also but no component is damaged .

the only solution which i know is keep changing the yaw roll esc board till it is aligned . dji firmware tolols master (python) not working on phantom gimbals . correct me if i am wrong . some people are having calibration tool for yaw roll esc board . i tried to buy that tool but didn't find...

p4 pro and p4 pro v2 gimbal flex is same

Hi all recently got a problem in phantom 4 pro v2 . it has been crashed and damaged from bottom side. flight controller has one sign of force on it but not damaged . now when turn it on and check in about section it is not showing flight controller serial number. it is not showing any battery...

Hi all Found 1 motor with some debris in coil . Replaced that motor , drone is in sky again . Thanks all

I am having same issue after changing the yaw motor and yaw roll motor esc board . Gimbal is facing left side . Anyone can help with yaw motor roll motor esc baord calibratiin tool please. It is not even calibrating with dji firmware tools master (python). Thanks in advance

Hi sir My drone met a crash recently into power lines. Drone survived to hover after crash. But body, yaw motor and landing gears were damaged. Yaw motor was in half hanging position when i landed the drone. Flex cable and yaw arm was intact but when i changed yaw motor reassembled the drone...

Same problem with my phantom 4 pro v2 after changing yaw motor. Waiting for solution

Hi all Recently my phantom 4 pro v2 met a crash. After that i changed complete body, yaw motor and landing gears. After changing all things i did 10-15 test flights. In between these test flights drone fell on its own twice. Once i saw motor failure written on top left. Both esc boards and...