Recent content by riderson

Hello everybody, I recently flew lightly into an obstacle. Now I neither receive any Video from my camera nor can I start recording video or change image settings. I can still see all the flight data, gimbal data and settings. Gimbal ribbon and gimbal itself looks like it's in good condition...

This happened when I tried reinstalling: [00012651]========== Upgrade: remo-con disconnect. boot(1FF7)============ [00012755]Packet [C:\P3C_FW_V01.07.0800.bin] detected, card sn [0xda6ad315]. [00012856]Packet upgrade start... [00012963]Packet checking... [00013067]Packet vlink 01.07.0800...

I have a phantom 3 se too and took its gimbal controller and antennas This is what happened:

In that case, do I just switch out the gimbal main board and the antennas?

I tried upgrading my firmware today to P3C_FW_V01.09.0200. Unfortunately it failed. Does anybody know what [00606769]Packet upgrade failed at last version checking, Ret = -1. means? Remote was not connected. Before the update I've been having issues with my video and telemetry transmission...

[00006561]========== Upgrade: remo-con disconnect. boot(66E7)============ [00006755]Packet [C:\P3C_FW_V01.07.0800.bin] detected, card sn [0x80b34224]. [00006853]Packet upgrade start... [00006953]Packet checking... [00007094]Packet vlink 01.07.0800 <-> 01.07.0090. [00007190]Done...

did it exactly like you said, no luck... The phone is conncted to the remote, I can fly the drone, start the motors, just no video or telemetry signal on my phone. Remote controller led is red. Drone leds are green

Sounds interesting, I'll try that!

I'm running the latest firmware. All the indicator lights are green too. Could there be any other hardware problem that might cause this issue?

I've built multiple drones before and this is my second p3 standard. I'm wondering if maybe one of the 2.4 ghz antennas in the drone is broken or something like that. Is there any way of checking if the drone is transmitting data on 2.4 GHz? (Other than trying to connect a remote)

Phantom 3 xxx, its the remote, I always connect the phone with the remote before I power on the drone

I've tried both procedures multiple times without an success. Still only 5.8 and no 2.4

The stick inputs are coming from the remote. I said it, to clarify, that the issue is not the connection between the phone and the remote. The problem therefore must lie in the 2.4 GHz connection between the remote and the drone (the video and telemetry band). The 5.8 GHz connection is fine, I...

I tried binding the p3 with the remote again but nothing changed, as stated in my first post. the stick inputs are the values from the stick positions, that are sent to the drone. In the controller menu of the go app you can see a diagram, that shows you what the values are. Im able to see all...

exact same issue here. Only that I didnt crash from that high. Another thing I checked were the antenna cables from the gimbal controller. They seem to be in great shape though... still looking for a solution