Recent content by realjg

Check out SelfCAD.com Sent from my iPhone using PhantomPilots

I love SelfCad.com check it out, its how i learned 3d printing Sent from my iPhone using PhantomPilots

How difficult is it to install the compass. I need to open up the whole drone?

If everything works fine (i did notice every second or two on my phone display when i tested it there was like this small little lag) should i keep flying? What would your advise be?

Ok. After inserting the wire where you saidZ It snapped in easily. I took it outside, turned on, calibrated the compass and it all seemed fine. Unfortunately I wont be able to put the props on until Sunday and check if it is working. There might be sand in one of the engines, should i take...

Those include compass wires? Where can i buy compass wires?

Are you saying it should squeeze in where the gold dots are?

Where exactly is that?

The more i force it, i am afraid i will damage the compass wires as seen above. Sent from my iPhone using PhantomPilots

Sent from my iPhone using PhantomPilots

Seems to be a small indent here preventing me from pushing the top through Sent from my iPhone using PhantomPilots

I have tried with considerable force. My last thought it to remove the cover for the compass, snap back in and screw back in the compass cover. I am also traveling now and I don't have a screwdriver of the size on me. Does DJI include one in the original packaging?

So I crashed my drone trying to fly (show off) into a wall :/. Everything seems fine but how to I reinsert the antenna which is on the leg of the compass. There seems to be something preventing me from snapping it back it. Do I need to unscrew the compass to snap it back in? Or use more...

I just pulled my P3A controller out of the box, turned it on. And it was dead...plugged it in to the charger and I am getting a blinking white light. Already 20 minutes like this? What to do. I haven't even flown yet. Sent from my iPhone using PhantomPilots