Recent content by nick9955

Turns out it was a bad motor. when I mounted the motors I must have screwed the bolt in too far. Which is odd because when I took them off I noticed they were very very tight so when I replaced them I was very very gentle yet I still damaged the motor. I feel like this is a major defect with...

I did buy the drone used so not sure about the history but since I have been using it it has worked fine and I have never taken the bolts out until I did the imu and when I replaced them I kept the prop guards in place so don't think thats the problem. Although when I unbolted the motors I did...

Ill install a new motor they arent too expensive and see what happens

removed it from the box, I wasn't sure about doing this but it hadn't worked from just tapping the outside and the guy on yt took it apart too so I did too

nope no errors in the app. Could it be a bad motor? I thought that when brushless motors burnt out they completely stop.

cant seem to post videos is this even possible? here is a screen shot you can see the rear is hardly moving and a lot slower than the others i can give it a push and it will spin faster but not fast enough for flight

yeh was all level when calibrated and nope props are all in good shape. will post the readings now and a video of what's happening too

yeh props are on the right motors and was a manual take off. and when the props are off it seems fine,, but under load the rear isn't spinning right and i'll give stick calibration a go. I have also tried to take off whilst holding it to see if it would pull up straight but it doesn't it...

Hi I have searched but couldn't find anything relevant (also I'm new here), So I had my Phantom 3 standard in the cupboard for maybe a year without flying. I went to fly it yesterday said it needed IMU calibration so tried to do that and it didn't work it kept failing at 2%. I saw you can fix...