Recent content by nettraptor

i think that , the V2 is definitely from the beginning of P2Vision out there,, i am 100% sure that they just re flash there already existing ESCs to the market. basically same hardware different software 3 minutes job to update them.

i have a vision and when i got it , i bought a H2-3d , it works Flawlessly i git also a iOSD and 2.4ghz video from boscam

i have a P2V and i run a Zenmuse H3-3d NO PROBLEM!!!!!!

I ve notice that the Gps reception of the phantom 2 generally is poor... while in the sky there are some times 12 sats , i only pick up 7 .. why?? Ok ive read a lot of discussions about it , and i try several things , alouminioum tapes copper tapes nothing.. i found the 3M™ Fabric Tape...

You mean is normal?

I don't know why but I just change channel in video tx and RX and magically everything worked

Hello there I just finished my fpv setup with iosd and video tx the problem is that if I connect "power" the video tax I cannot find any satellites. If I unplug the power from video tx I get satellites . I am using 500mw boscam....

if i am not wrong the CAM port uses 6 i think is 51021-0600

Ohh now I get it. And what about your radio part ? What antenna do you use??

What do you mean only one antenna?? A cloverleaf to phantom and a whip Sto antenna to radio?

Hello my board is exactly like this http://bradatech.com/xPedRobo/shop/inde ... cts_id=346 There is a port say "zenmuse" Is it compatible???

understood! I might go to a solution more practical . i will find a gimbal for VISION camera any recommendations?

hi there, i ve been flying multis since 2009. i got in my hands a Phanton 2 Vision NOT the Plus i need to know if i can install the Zenmuse H3-2D or Zenmuse H3-3D is the P2V software and hardware wise compatible with the zenmuse?

hi there, i ve been flying multis since 2009. i got in my hands a Phanton 2 Vision NOT the Plus i need to know if i can install the Zenmuse H3-2D or Zenmuse H3-3D is the P2V software and hardware wise compatible with the zenmuse?