Recent content by Nekenieh

Thank you @HappyStandardOwner and everyone else for the fix and updates. I bought a second-hand P3 Standard with bad RC signal and could not go further than 150 meters except with Litchi where I could go miles away while retaining video signal so that was a good alternative. Obviously i wanted a...

Normally one can feel the friction or different feel by turning the motors by hand but in my case i guess it was on the edge of being blocked intermittently.

Maybe when enough rust causing some kind of friction between stator and magnets to cause obstructed motor message which i got occasionally as well beside the ESC problem. Just a thought

Stators rusty as hell! Also the magnets

You can request the firmware via DJI administrators and state model. Probably this FW has a different ESC logic to bypass a dirty coil but i still think in most cases the root cause are dirty or corroded stators. I had ESC error with often engines not starting at all and rarely 1 engine had...

Try this first: Firmware v1.11.30 for ESC error??

I had the same in automatic mode mostly in cloudy/misty kind of weather. With ISO200 or less somehow i don’t have this noise. I’m not a photographer but this seemed to be the solution.

Just flash normally!

I had the same! Normally it’s corrosion in the electro engines not being used for a while and stored in a humid place. I disassembled them and cleaned them with very fine sandpaper and alcohol. Also i sprayed them slightly with contactspray. Put them back together and errors where gone with...

Otherwise it looks like your pitch motor is u/s.

Have you tried to calibrate gimbal in the DJI-GO 4 app? Not the IMU i mean.

Try reinstall current Firmware with binding button. Youtube has instruction videos. It also generates a new logfile so you might see which module is wrong.