Recent content by Mnap20

I’m throwing in the towel…I’ve tried my damaged camera and get all the errors. Selling it as a parts drone and buying another one built for what I need it for. Thanks for all your help

I removed everything and I get an esc error. I think this is tied back to when I crashed it. I’m fairly certain there is damage I cannot see

I’m looking to use my P3P without the camera. Has anyone removed it and flown successfully. I’m using the drone for a specific reason where it’s always in my sight and no obstructions. What is the process to be able to do this?

Your help is very much appreciated!

Having problems with pushing new firmware. Does the red/green flash for about 30 seconds and goes to the solid red. I’ve restarted the drone a couple times but no difference. Tried a couple different firmware versions, does the same thing. I formatted the sd card prior to any firmware update...

I’d like to downgrade but couldn’t find the version to download. I have a new sd card that I formatted through the go app

That’s correct, there are no updates required or available in the Go app. Camera does the dance on startup and can be controlled with the rc wheel. Still getting a battery error which wasn’t the case before I had opened up the shell. On startup, drone camera will alternate red and green...

The firmware had been updated and everything was fine, I’d get a solid green light once it went through the motions. It’s now all of sudden it’s the solid red with a solid tone almost like something is stuck

Yes that is correct.

I have not reassembled the shell. Everything worked fine leading up to the crash so I don’t think incorrect screws were the culprit. All plug in connections are fine. I pulled them out and plugged back in again. I get a beep for about 10 seconds then a solid tone with red light on camera.

No obvious signs of damage under the cover. Now I’m getting a battery error and my camera light stays red, and sustains a steady sound like something is stuck. No idea how that happened out of nowhere. I’m thinking this drone is toast

@quaddamage, as of now the camera and ribbon cable have been replaced. The camera will do its dance upon startup which it wasn’t previously doing which is good. I get the 4 beeps when the drone is powered on. It says the drone is ready to take off in the app and soon as I attempt to, I get ESC...

I haven’t taken the shell off yet I’ll look for a loose wire