Recent content by MILLER4PRESIDENT2020

glad we cleared that up. thanks

updates may get you excited however i dont want to have less functionality and range. The purpose of me asking was to see if this was a trend with updates over the last year or two

Life got in the way and I want to get back into flying again. Obviously I have a ton of updates pending. Firmware, software, etc. I dont know what all my updates are currently at but I am sure I can look. My question is should I do them? I know in the past updates have typically made things...

Thank you good sir! We should just pin this and not allow 50 million responses afterwards that way everyone can easily follow along

Sorry I must have meant 250 mW. There must be some sort of device that I can take the laser out of its housing and solder the remote controlled on off switch between one of the battery wires and the laser. Something like a garage door opener or a remote car start switch that transmits a...

it cant be that hard to find a cheap switch that I can wire in between a battery that is able to be controlled with some sort of remote signal???? But I dont know even where to look or what frequency could control it?

I have this desire to mount my 250w laser on my drone. The problem is you cannot run the laser for more than a minute at a time otherwise it will overheat, so that is a very short flight. I need someone to build me a remote switch that I can solder into the laser so that I can turn it off and...

Me too. Everyone just points you to a 54 page thread and complains when a new thread pops up. I dont want to readt through 50 pages of sub conversations and moved link and obsolete information and people quoting other posts from many months ago! Its like trying to figure out a soap opera from...

These people who claim they know the secret yet wont tell are really pissing me off. No men in trenchcoats are going to come knock at your door. The FAA has more important things to do than to chase hearsay. There are way more videos of people on youtube doing questionable things with...

I dont seem to remember the first phantom having any sort of altitude limiter on it. Can someone hack that naza firmware and transfer it over somehow?

Stupid question? I thought the phantom 3 came in standard, advanced, and pro? The pro being the only 4k. I have the advanced which is 2.7k. Is this better than mine? And cheaper? Is it also lightbridge? I am confused now DJI - Phantom 3 4K Quadcopter - White

There must be other less popular quads with no limits built into them. Anyone have any good recommendations off the top of your head?

I have taken apart and replugged in the Y ribbon and the grey cables with the latches several times to no luck. They are very small and there is really no defining "click" that tells you everything is seated properly, but I have tried taking apart and rewiring 10 times now. I don't see any...

I presume that ribbon cable that splits into a Y and has two connections on the gimbal board?....once connection is for video feed and the other for control of the gimbal? Because I get neither. It is a funny connection getting that ribbin cable back in, there is no clamp or anything to use to...

doesnt even do an alignment dance when I power it on, just hangs there and immediately goes into error lights. I can swing the gimbal freely by hand so nothing is bound up inside