Recent content by micgin81

is a link to video. Also does anyone know an independent repair shop in Denver Colorado area. I tried the big shop that shows up on Google maps. They said, sorry no parts send to DJI.

This is a video after a hard landing/bounce. P3S kept flying but the gimbal started doing what you see in this video. There was no visible damage. I replaced...

I have seen the videos about the roll motor shaft position and believe it is facing in the correct direction. I will check again. It is either facing directly up or directly down. In the videos most were not straight one direction or the other. Any case I will check. I am also headed to...

I replaced the yaw motor. Still doing the left right motion. No difference. Any more ideas

Thanks. Well it did bounce and kept flying. Gamble calibration failed. I checked all the gimbals. The move freely with no binding. I check what I could see without taking apart. Is that the white plug in the picture.

Thanks, where did you get parts for fix? I tried the local DJI repair that shows up in Google Maps in Denver and they said, sorry too old of model for us to get parts.

I had a hard landing/bounce. The drone kept flying but you could see something wrong with the gimbals. I landed. No visible damage but the now the yaw gimbal goes full right to left repeated until you get a gimbal overload warning. Drone flys with no problem just video useless. I have video but...