Recent content by mdeep

I had same problem. I downgraded my firmware to prior upgrade and it's back to normal. Make sure you do the drone first then any extra batteries, then the remote controller. Hope it helps you Sent from my SAMSUNG-SM-T337A using PhantomPilots mobile app

I'm running one version behind b/c I was getting lines in my video feed after last update so I downgraded time prior update. Video feed is fine now but I lose rc signal at 2400 feet and rth initates. I checked distance limit and it's not on. Anyone know why this is happening? Sent from my...

So I opened it back up and unplugged the ribbon cables then plugged them back in closed the little doors on the cables and screwdriver it all together again. I turned the drone on then turned the remote controller on and the picture was great. After about 60 seconds I started getting lines and...

No soldering or splicing. Just inserted new board and connected 3 ribbons and screwed everything back together. Weird that the video to my goggles if perfect but in the dji app video is getting the lines. I open it back up and everything is connected correctly. I will disconnect the ribbons...

Need some help. I put on the HDMI output module onto my controller and now am getting a lot of lines on the video feed on my Samsung tab 4 in the dji go app. The video feed coming out of the hdmi port to my dominator v3 goggles is perfect though. I did not have this problem with the stock...