Recent content by loulan

They don't but will they exchange your drone with a refurbished unit for a few hundred, like they seem to do when it's too much effort to repair your unit? That's more my question.

After a few years of decent use, what had to happen happened, I had a pretty bad crash with my Phantom 4 Pro V2.0. I was flying on the beach, it hit a tree I hadn't seen, and it fell in sea water (it was still on the beach but basically a wave drowned it entirely). A good thing is that the...

Thanks a lot for confirming! It's really odd that one of the connectors is supposed to remain empty, but I guess they just didn't want to redesign the Power Interface Module for the V2.0.

Okay I'm pretty sure I've figured it out. The white compass cable from the back right-hand corner should simply be connected to... nothing I believe. And one of the connectors from the Power Interface Module should remain empty. The Phantom 4 Pro V2.0 probably only uses a single compass. That...

I found an old picture that dates back from when I took my drone apart, which shows the setup it had: In the back left-hand corner: gray antenna cable. In the front right-hand corner: white antenna cable. In the front left-hand corner: gray compass cable with a large connector that I can...

I don’t understand what you are saying, what I circled in green is where the module is, so the end that is there (circled in red) definitely reaches it. It's the other one that's too far away. Anyway, are you saying the drone works with one of the compasses disconnected in the landing gear?

If I flip both, the problem is the same: the two compass cables are still in opposite corners, just the two other ones. As long as the compass cables are in opposite corners, they can't both reach the front of the drone (where the Power Interface Module is).

To illustrate my issue: the connectors from the compass are circled in red. Where I need to connect them (where the Power Interface Module will be) is circled in green. For the top left connector there's no issue, but the bottom right one is way too short. It seems like I cannot make both of...

So, it looks like the way the landing gear is connected to the rest of the drone is different in the Phantom 4 Pro V2.0 as compared to the Phantom 4 Pro, and it's really annoying because it looks like every video online shows the Phantom 4 Pro. Basically, as can be seen here, with the Phantom 4...

I don't manage to unscrew the tiny black Phillips screws that are used for the Power Interface Module or the left/right ESC sensor boards. What I'm talking about is the four tiny ones in this picture: I'm using the Phillips #0000 screwdriver from this kit: 6 pièces Tournevis de précision, Mini...