Recent content by lostkiwi

No longer have a drone.

Its a higher voltage. 3s is 11.1v, 4s is 14.8.....

No it won't. At 112mm long the 10C is tight as it is. The 30C is another 30mm longer.....

You did do the compass dance after all that other stuff you did didn't you?

Don't be ridiculous. Everyone knows its the drone pilots ejector seat button.

Left -> bottom left, right -> bottom right works as well.

The chances of two with the same issue is pretty slim - especially given no-one else is reporting that issue... Are you sure you're following them right procedures?

Much as I'm not a huge fan of the GoPro (as a camera) its the easiest way as other folks have put in all the effort to see what works. I'm not aware of anywhere they give the range for the in camera WiFi for any manufacturer.

Or... change cam to one with video out (like GoPro); also get a mount for it - add 1.2 Ghz video transmitter/receiver/monitor setup - add mini iOSD for telemetry - change out mainboard for P2 mainboard (cheapest way to add CAN bus needed for iOSD)

Like this....

Most in camera WiFi systems will have a very poor range - some as low as 50 feet!

Most people use velcro. I sure as anything wouldn't want to use a magnet.

Don't descend vertically or descend more slowly.

If you look closely at the bottom of the arms you will see a small black rubber bung. If you look closely at that you may just see a pair of wires cut level to it or perhaps slightly recessed. Those are the ones you want. If they are pushed in a bit you'll probably need to slit the FC40 and push...

The difference between CE and FCC is only transmitter power. CE is a lower power output setting than FCC. Its highly unlikely anyone would know what mode you use.