Recent content by jupidu
-
J
P3 SE - solution to switching between FCC and CE mode, I used both, and it works for sure!
We've tryed with the 3.1.8 version above with "russian moded" firmware 1.3.20. First we've enabled FakeGPS, turned on remote and AC and connect it. After the wi-fi notfication popped up, we've closed the app without hitting "OK" and deleted it with all the folders and settings and install...- jupidu
- Post #183
- Forum: Phantom 3 SE
-
J
P3 SE - solution to switching between FCC and CE mode, I used both, and it works for sure!
Couldn't find that Litchi supports P3SE... due to DJI not releasing SDK for P3SE yet.- jupidu
- Post #91
- Forum: Phantom 3 SE
-
J
P3 SE - solution to switching between FCC and CE mode, I used both, and it works for sure!
One of the possible solutions could be changing the stock FW .bin file the same way it is done for P3 Standard / 4K. Changing the line in /etc/init.d/rcS file where it sets country to "GB" and change it to "OK" for example. This would not load requested module for EC mode which sets tx power...- jupidu
- Post #71
- Forum: Phantom 3 SE
-
J
P3 SE - solution to switching between FCC and CE mode, I used both, and it works for sure!
Hello, Thank you akossss and all of you for the effort to find a solution for CE restriction... I don't own a drone but my nephew does. We've tried the first workaround with FakeGPS app and I would say the drone was in FCC mode... We didn't try to fly and test it, cause the notification about...- jupidu
- Post #45
- Forum: Phantom 3 SE