Recent content by Jagtech

Be careful of screw length can cause motor failure if to long ( been there and done that ) LOL

Was thinking more range but if it is light bridge your right it is not compatible so maybe if i can try this. I think I can get that range by using Litchi app and way points. I already have the ARGtek setup just want to get out to 2 miles. Not sure how safe that is but then I am looking into a...

What is the controller frequency used on the advanced controller to control the air craft ? Is it 5.8 GHz If it is can it be linked to the P 3 standard. Saw somewhere that the advanced controller had more power.

Just to let everyone know the seller I got the drone from refunded me $180.00 so I purchased a center board for $130.00 for the drone and that fixed all my problems I got 10 satellites locked in before I even went outside and the motors came to life

Loaded older firmware today (1.05.07) and went to re calibrate compass but kept saying magnetic interference going to try a different area tonight.What's the chances of needing a new AC center board? Oh and the app says connected and the light on the controller goes to green soon after turning...

Noticed I have not been able to power motors on either

Got new GPS module and installed it went outside and calibrated compass with success and still no satellites.Waited 5 or 10 minutes still nothing not sure where to go from here.

blu studio is what I have and thanks for the body shell info been looking at u tube for taking top off drone.

I am outside and cal compass twice with good result

Thank you for the fast reply, module will be here tomorrow

I am new to this forum and my phantom 3 I just bought used When I load and connect with DJI go app no satellites show up or lock on I am using a android tablet and also an unlocked Blu phone with no sim card. My question is the app using the GPS in the drone to lock on or the tablet and phone...