Recent content by ITGuy1024

Got a summary?

When I put the ArgTek on my P3S it made the range and signal quality way worse.

My video feed has been laggy since the last firmware update.

So I looked over the guide to setup an android tablet and DJI GO. Some of the settings don't seem applicable anymore. For instance the setting to change the video feed quality. Unless I set it to manual and not auto there is no option to change quality.

I'm using an Android tablet. It's worked great until recently.

That's a pretty helpful guide for install actually. I believe I have most of that correct but I'll double check the settings. Thanks!

As of late, I believe after a recent firmware update the video feed is super choppy and laggy. Even if I'm right next to the AC. I think it might be app related because sometimes it gets stuck on the splash screen and I have to force close it a few times (Galaxy Tab 3). I tried switching...

Happened to me again the other week. Initially turning everything on only the RC was connected. Had to reboot everything to get the AC connected.

How fast were you going when you over shot? Looks like it smashed into something pretty hard.

I'd try to do it professionally full time but my day job pays way too well for me to quit haha.

Yeah that would certainly shake up your day haha.

Hey all Tonight I had what seems to be a popular issue "aircraft disconnected". Even though the app wasn't working I still had full control over the aircraft. Thankfully it happened before I got in the air. No issues at all prior to this. My troubleshooting steps were the following. -...

Yeah I didn't find your drone. I just wanted to make sure I read your post right and 2015 wasn't a typo. Good luck...

You're trying to track down your lost P2 from 2015?

I can't speak for the parabolic booster but I put the BlueProton ARGtek antenna kit on my P3 SE and the signal is the same, sometimes worse than stock. Save the money.