Recent content by ibantxo
-
phanton no ok
Problem solved. I have been changing the control module and everything is correct. THANK YOU JASON FOR EVERYTHING- ibantxo
- Post #42
- Forum: Phantom 2 Discussion
-
phanton no ok
Could it be because of cracks in the casing?- ibantxo
- Post #40
- Forum: Phantom 2 Discussion
-
phanton no ok
the module is already changed Now what happens to me that is going perfect only fails me when I go down, low slow unstable pulling a little to the right. Can it be from the module or from the carbon propellers?- ibantxo
- Post #39
- Forum: Phantom 2 Discussion
-
phanton no ok
What else can I do? but I will change the naza module- ibantxo
- Post #37
- Forum: Phantom 2 Discussion
-
-
-
phanton no ok
sorry but it is very difficult with the translator. I have the phantom 2 non-vision, the one in the photo is a phantom 2 vision for pieces. I answer the questions. 1. All accessories are the same as dji 9443 2. Maza M 3. Yes my phantom is this- ibantxo
- Post #32
- Forum: Phantom 2 Discussion
-
phanton no ok
When you takeoff is the righthand switch (S1) in the upper position and are you in Naza-M Mode in the P2 software. I'm going to change the main board because there are controls coming from- ibantxo
- Post #30
- Forum: Phantom 2 Discussion
-
phanton no ok
next step change Part 9 MC Board - NAZA Flight Control System- ibantxo
- Post #28
- Forum: Phantom 2 Discussion
-
-
-
phanton no ok
calibrate the controller first then theP2- ibantxo
- Post #23
- Forum: Phantom 2 Discussion
-
phanton no ok
It is already calibrated. everything remains the same. other solution?:(:(- ibantxo
- Post #21
- Forum: Phantom 2 Discussion
-
phanton no ok
ok, calibration p2 finish.transmitter version is in either upgraded or basic?- ibantxo
- Post #19
- Forum: Phantom 2 Discussion
-
phanton no ok
I do not detect the driver in your software :mad::mad:- ibantxo
- Post #17
- Forum: Phantom 2 Discussion