Recent content by Hummingbird.UAV

The update.zip file is only for a P4Pro+ transmitter with a built-in screen.

You should not have to update the drone or transmitter. Have you downloaded the latest GO app for your phone or tablet?

Use this link to download the file, copy it to an empty micoSD card, install it in the transmitter, turn it on, and follow the prompt. update.ZIP

Thanks again Pasayan19. Installed the 4P+ file and the maps are working in the Go4 app!

Sent you a message.

It is very kind of you to share the file, what would be the process?

My thought is that the "update.zip" file would have installed the latest version of Go4.

Did they give you a link to a file named "update.zip"? I downloaded this file a while back but it failed during the installation of Go4.

My same problem exactly. Sent my Tx in because of a charging problem. On this one the maps worked, DJI sent a replacement but the maps did not work. Lots of firmware hocus pokus nothing worked. I was sent a link to a file called "update.zip" which I was to run directly from the micoSD card...

Sadly none of this worked on my Gl300e, still have a black mapbox.

I got a link from DJI support as well, downloaded the file put it on a micoSD and it got stuck at installing Go4 at the 10% level. The fix in the YouTube video did not work either.

Any chance you can post the link? Maps in my Go4 are blank also.

I have never come across one. I use the HDMI cable going to my goggles.

I assume your transmitter has a HDMI out module and that is how you connect to the goggles using a cable. Note this is a digital signal. The NexwaveRF is an analog device and the two signals cannot be mixed even if they are on the same frequency.

Yes mainly because the camera is NOT mounted on a gimbal. Cranking up the gains in the NAZA flight controller also might steady the drone/video a bit better. This is an old self constructed drone kit from ~ 2014.