Recent content by HmoobLis

Thank you sir!

Yes. I do have the updated controller with gimbal wheel . Any help would be greatly appreciated . Thanks!

From the little information I can find, looks like the Zenmuse H3-3D or H4-3D should work for the Phantom Vision+. Can anyone confirm this? My camera and gimbal is toasted, and I already have a gopro hero4. Looks like folks on the "E" store online want an arm and a leg for a used DJI PV+ camera...

I found some pics online. Thanks.

Can anyone show me pics of their wire connector? I think I may have 1 wire in the wrong slot. My camera wont initiallize and is beeping at me now. Otherwise my camera is bad. Long story short, I replaced the flex cable. Maybe I don't have the cable seated properly.??????

Phantom 2 Vision+ Gimble and Camera wire harness/cable/connector. Need help with actual connector and wire harness. A picture is worth a thousand words. Thanks

What does it mean when your system light is solid green with a system light flickering? Bad or weak signal from wifi extender?

what are the chances my camera is still good?

Bad news. I was bored today and decided to go fly my drone. It was pretty windy and my phantom clipped my neighbors mailbox. Now, my camera flex cable has ripped and camera may be bad. It fell off the rotating axis. I was able to push the camera back on, but will have to see how things work...

Is the Wi-Fi module inside the drone?

Both lights are working. I did check the blue box twice and entered my Mac address manually. That was my only option. My camera couldn't read my q sticker. I'm going to recharge everything and try again later. Maybe a full charge might make a difference. And yes I hv restarted the systems...

Ok

David, I have followed your youtube video and instructions above. After doing all the above steps several times, end result is that I still cannot connect. I have tried this on two different cell phones with same results. So, Here's what I am noticing. -After I reset the range extender, I can...

I I cannot connect to the DJI VISION APP to use the features. Although it looks like I may be connected at the home screen, but cannot see and live feed vids, pics, battery life, satellites, range, mph....etc.

I am a new pilot and cannot figure out why I cannot connect to my Phantom2Vision+. I can fly calibrate and fly fine all day, Just cannot connect. Any help would be appreciated. No crashes and all cables look fine. Thx