Recent content by FaFab

Procedure tested here an problem solved :D Thank you Quaddamage!

Thank you @quaddamage !! Mine works fine now:) For me, the hardest was: Press ESC to abort autoboot in 1 seconds Dji-Pro # In the Re-flashing primary kernel procedure. :p Great tutorial and thanks for the zip unencrypted images. Just 1 thing you forget: In the Re-flashing bootloader Chapter...

? Cool! I'm ready to test it! :)

Thank you WSCorp65; but as i said on my 1st post: That's why i think the usb board have an issue and i would try to flash it. I followed some threads: https://phantompilots.com/threads/no-luck-flashing-gl300a-p00928-03-usb-board-via-ftdi.136862/...

I tried to flash the usb board with usb-ttl card but i meet some issue in the procedure... NB:I've already flash the gimbal main board and it works perfectly But the difference between the two procedures is for the remote, as i understood, i have to decrypt the firmware before flash the board...

Little feedback: I bought a 7€ usb-ttl, spend few hours in github and my gimbal works fine now :) Video live on dji go is ok Thank you for help

So, If dji go doesn't detect my rc and if my rc doesn't detect any usb flash drive; It's dead for it ?

Thx Oso [emoji6]

So, if i put a p3a gimbal main board in a p3p, i have to use a p3a firmware in the futur. What functionality i Will lose ?

Ok, thank you for your answer and for the link! great diagram ! I was ready to send it to Dji support but maybe i will try.

Hello, Do you know if It's possible to replace a p3p gimbal main board by a p3s one? Thank you.

Yes! -When i put a sd (on rc) Nothing happen. = Put a micro sd in an adapter to the RC usb port. Why you think about that?

Nothing is new, i bought them used.

Hello, It's m'y 1st post, i'm a New p3p owner [emoji16] I just bought a p3p with an issue (i known that) Actually: -When i link the Ac to the RC, i have on both of them a green/red blinking led. -When i connect my Phone, Nothing happen -When i put a sd (on rc) Nothing happen. -rc and Ac are...