Recent content by Doidling

No replies so I went ahead and tried a few things. It turned out that the camera tilt shaft was rotated 180 degrees. Apparently I misunderstood point 4. If someone sees the thread later it should be that the flat on the should face the camera back.

I just rebuilt the Gimbal on my 4K camera after a crash. I replaced both arms and the ribbon cable. As soon a I turn on the drone it starts swinging the camera wildly. I know that this is a common problem if things aren't put back just right. I've checked all the problems I've found in forum...

Tilt shaft orientation

Camera orientation