Recent content by docrock066

Thank you

Thank you, I'll give it a shot. The first time it happened it was on a level surface, went flying again today and received the message again, but, it wasn't a perfectly flat surface. Thanks again.

Today after a first battery flight that was mostly uneventful I changed the battery to a fully charged one and after turning it on I received an IMU initialization message, telling me not to move the drone until it was done. After a short time this message disappeared and received an encoding...

My experience with DJI's repair service was good. They were quick and I thought reasonably priced. Not sure but if you contact them they might send you a shipping label, I can't remember for sure.

Top Gun is no longer at Miramar. Moved to Nevada, Fallon I believe.

And thanks for the reply.

That's probably what happened, I don't deny it couldn't have been my fault, but DJI said first, it was landed on an uneven surface, and second, that I caught it. Both totally false.

A couple of months ago I received a replacement for a crashed drone, a P4P V2. On the second flight after receiving it, it took off from my driveway and entered its initial hover. At that time I got a "disconnected" message on my screen but the drone would still respond to the controls. I...

I doesn't work on all the cables I have, some are brand new, came with Ring cameras so I would think they would be good quality.

I didn't supply adequate info. Its a new P4P V 2.0. Less than 5 hours on the system. I switch cables and it works fine.

P4P V 2.0

Yes the remote wheel moves the gimble. I change cables and it works fine.

Ooops, sorry about that, its a P4P Pro V2.0, less than 5 total hours on the system. Seem to remember having the same problem on previous P4's.

Any explanation as to why I have problems getting a cable, tablet to controller, to work. I have several, some brand new and I think high quality and an assortment of others and not all work. Message on tablet is "not connected". Thanks in advance

Thank you