Recent content by cwright

Ok not sure exactly what fixed the throttle issue but it is back to normal. The lights are back to normal as well. I did reinstall the latest version of the firmware and recalibrated everything. Now all is well again. Chuck

Our store demo has developed a couple problems. First is when linked up to the software on the computer an error pops up on the screen unable to start motors as throttle mid stick setting is to high. We are using the stock radio. I have done the transmitter calibration several times with no...

Thanks for the reply. I don't mind this sequence, in fact I like it better. Less confusion on power up. Wanted to make sure it wasn't going bad. Thanks again. Chuck

It seems our Phantom has a new sequence of flashing lights. When powering on now we only get the yellow flashes showing IMU warm up. The switch is in GPS mode no green lights or red for satellite. After a couple minutes the yellow goes away and then I get the green light and the red lights...

We tried regaining control today with no issues. Move the switch to the center ATTI position as mentioned. From there you can switch back to GPS mode. This also works after landing. No more need to unplug the battery now I know how to do it. Chuck

Yes I believe it is a feature of the new firmware. Chuck

On ours we can't regain control. We have to unplug the battery to recycle it. Also when we tested ours we only had the green light and no other colors which is great. Very accurate in 10 mph wind. Chuck

I programmed the Phantom to go home and land using the ATTI switch. It works fantastic. We tried using it 4or 5 times. We painted a small dot on the ground and placed the Phantom over it. Every time it landed it was less then 1 yard away. Simply amazing. I am old school and I couldn't make...

So I can program the switch in the software so all the way down can be fail safe , and if I have the go home and land setup in failsafe it will work like turning off the transmitter? Sorry for all the questions but since the store has let me learn about the Phantom I have been quit fascinated...

Our store has a Phantom demo. I am trying to learn all I can about it. I have watched several videos of it. The question I have is the GPS switch is a 3 position switch. GPS is at the top, then ATTI in center and ATTI at the bottom. What does the 2 ATTI modes do? I will get my own Phantom...