Recent content by Cuboide

UPDATE Camera issue sorted. All working including SD card being read. I changed the camera encoder board, bought second hand from China.

@theprince_62 Prince you may have some suggestions on this topic as well. Thanks!

@Halda I read your post and I understand you may know a way to fix Amberalla on a P3 standard. Can you help please?

@bulbo77 I read your post on the Amberalla issue you had. Would you have any suggestions how to fix the issue I have, it could be I need to reprogram the nand but the chip connected with uart is unresponsive. thanks!

tried that, nothing

Did some test on the dongle connecting TX and RX together. In Putty I can see what I type so TX/RX are working. On the circuit board not sure if I connected the correct service pads for RX/TX, I used U0TX and U0RX but I see other pads like U2 and U3 so not sure I used the right ones.

thanks Captain, let see how it goes, itis mostly for fun, to learn this stuff 💪

I received the TTL-USB dongle. installed the driver, downloaded putty and also Termius. I made the soldering connections to the board. Despite trying all settings Boud / COM matching etc I cannot type or see any code in the terminal/s. Not sure what I am doing wrong. Also tried the dongle...

ok thanks for clarifying, I thought the board could have been powered by the TTL/USB

@quaddamage When I receive the USB-to-TTL dongle I will connect the circuit board with 3 wires to work: RX, TX and GND. Do I have to connect also the 5v service pad? 0nce all is connected, how do I read the chip? is there a string I have to load on CMD in wind 10 or I need a software like...

also I powered the drone with the board on an without case cover to see if the green light was on just to be sure it is not ribbon not bringing energy

ok, I did not try any short and connected directly to 5v. the board powered up as you can see in the photo. I checked all volts with the multimeter and all are correct. we can move to the next phase, probably next weekend once I have received the USB-to-TTL dongle 💪

so basically with the multimeter I touch the 5v pad and each of the ribbon cable pin to check a short correct?