Recent content by Corri

Hi there A little bit tricky, but it is a wonderfull job. I fly all my jobs manualy, and I would do so also in your case if you have troble with Drone Deploy. With a GSD of 5cm you probably can not fly much more than 60m above ground. Divide the area in different subareas and search for a good...

Hi I'am based in Switzerland, near Zürich. www.mvpag.ch Maybe you are interessted.

Good afternoon We use our drones for survey mapping: Phantom 2 with Gopro Hero 4, Phantom 4 Pro V2.0 and Inspire 1. We use groundcontrol points and as software Pix4dmapper. Just at the moment we are evaulating ARGONAUT from Rokubun to reduce the workflow in the field for the ground conrol...

Hallo, see the thread: and what I posted today on these thread was: I had the problems since about beginning of september, after a firmware update. In the meantime I did some tests. After Osmo's tip I checked the dji no fly zone map and I noticed that I am living and flying on the border of a...

Hallo I had the problems since about beginning of september, after a firmware update. In the meantime I did some tests. After Oso's tip I checked the dji no fly zone map and I noticed that I am living and flying on the border of a no fly zone. So I did some starts near the border but inside the...

Hallo and thank you. I will check what Oso wrote. Unfortunately I have no posibility these days but I will check next week and I will inform you.

Thank you. I allready did a compass and controller calibration but it did not help. I will try a IMU calibration. By the way the problem are the rear status indicators.

Thank you, allready tried with compass calibration. Will also try with IMU calibration and let you know

Hi there I have a problem with my phantom 4 Pro V2.0. The led status indicator is flashing 6 times green and then 2 times red. And then 6 times green and 2 times red and so on. I can connect the controller to the Phantom and I can also fly with gps but there is a strange feeling to fly with...