Recent content by Bpace

I 3D printed a jig to help cut them to the correct width. If you have a 3D printer I can send you the stl file.

I used the old cable as a guide and an xacto style hobby knife. You can cut the entire strip or just 8mm off each end so it can fit into the connector. Install the cable with the exposed traces facing up.

Make sure it is 40 pin Type A, you will have to cut the width down to 32 pins wide. I'm just figuring this out too.... Like: https://www.amazon.com/gp/product/B07RZ8482M/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

Are you sure the ends are different sizes? Cant get to mine right now.

That is the one. Mine cracked after being removed about 10 times while I was working on the not charging issue. You can get generic ribbon cable for far less, you will need to carefully trim the width to match the original cable. 150 mm length is plenty long, example...

Could be a cracked ribbon cable?

Just to clarify, I had about 2 hours flight time on the new set of props/ mounts. I dont know if they were genuine or not, they were from ebay. They did look identical.

Has anyone tried these? Are there any more permanent mounting options?

Hello all, I have been searching but found very little info on Non quick release props for a P4. I did stumble on master air screw props for the P4 but all links went no where. The reason I want to get away from the quick release is I have crashed twice in 3 weeks due to losing a prop in...