Recent content by beigehornet

  1. B

    Hanger 360 - Pano software

    So i did a run with mine, lots of improvements to do with the app for sure, like the ability to focus the camera! It took off with a close focus so ever shot was useless.... But it took the images eventually..now what? It landed and what?
  2. B

    Phantom 3 standard - motor change failure

    Do you know if you need all 4 motors wires up for any of them to work?
  3. B

    Phantom 3 standard - motor change failure

    i have the bare copper, still not taking the tin very well
  4. B

    Phantom 3 standard - motor change failure

    These wires are not easy to solder, they dont want to take the tin
  5. B

    Phantom 3 standard - motor change failure

    THE PLOT THICKENS! thanks mate ill do some testing before i solder back to the board!
  6. B

    Phantom 3 standard - motor change failure

    Each, RED YELLOW BLACK - took the coloured insulation off, exposing the duel copper inner wires, i assume they also arent insulated in clear coating?
  7. B

    Phantom 3 standard - motor change failure

    I have not re done the solder, i spliced mid wire with in line connectors, do they need to be soldered into the circuit before they will get any flow?
  8. B

    Phantom 3 standard - motor change failure

    Is there any way to test if the board and controllers are toast? follow the voltage flow or too hard basket
  9. B

    Phantom 3 standard - motor change failure

    So bumping this a tad, since had the motors refunded, but issue i have is with the stock motors re connected they dont work at all. I have thrown a multimeter on them to see if i get any flow at all and nothin. Suggestions, or steps i can check to see why?
  10. B

    Phantom 3 standard - motor change failure

    The drone parts. Note no break to solder on any wire. I spliced mid wire to make it easier. And I rather not touch the control board. Stock motor doesn't react to the drone at all.
  11. B

    Phantom 3 standard - motor change failure

  12. B

    Phantom 3 standard - motor change failure

    I had an issue with one motor post crash. Swapped all 4 motors out but none of them engage. Put a multimeter on the cables but get no flow. Re connected the original motors and they also get no flow or reaction when attempting to take off. No errors on the app. Thoughts?
  13. B

    WTB in AUS Phantom 3 Standard

    As the title sais, im based in Aus, looking for a Phatom 3 Standard. Thanks
See more