Recent content by 93dakman

Do you find much lag between the feed and your control input during flights?

Hi, I operate a Phantom 3 Pro and 4k. I have recently been finding more work, but not enough to justify purchasing a $300 or more tablet. I am looking choose between these two. The Galaxy Tab S and the Galaxy Tab Pro, both in 8.4" (I do not do iProducts). I am not really looking for...

Due to not being able to update through the DJI app, I attempted to update the firmware through the SD card. I downloaded the update .bin file to my phone, formatted my SD card and moved the update file onto the SD card. Placed in drone and turned drone on. It went through about 20 minutes...

I have been using my P34k for about 6 months now. Had a few small scale crashes during my learning curve. Replaced the ribbon cable, and other hard parts along the way. A few weeks ago she fell out of the sky. Granted, after alot of research on here I realize it was my fault for decending too...

Just a bump. Need some insight from those that have experience.

Also, how likely is the roll motor the problem? Is it a normal problem area after a crash?

This may sound daft, but what ways can it be installed wrong. I imagine that if all connections are seated properly and the adhesive locations are firmly located, all should be fine. What other installation issues should I look for when I take it back apart? Also, what is the out of box...

This is what all photos and videos looked like before I replaced the yaw arm and stock ribbon cable.

I am having problems. My P3P was crash landed last weekend by my friend while we were out on a camping trip. The ribbon cable had a noticeable place that was damaged and a spot that had abrasion but not positive if it was only superficial. Also the yaw arm was bent and cracked. The symptoms...

*obvious signs of ribbon cable or motor* I can type, I promise.

Quick question. I have a few pretty brutal crash and burns with my 4k. I am having a situation where the roll motor/servo just gives up and the camera angle falls to the limp position. It may stay like the whole flight, or sometimes I can transition from a hard quick right to a hard quick left...

Again, I am new to the hobby and trying to learn as I go.

So I want to start this thread to learn about the different hardware available to boost the range of my 4k. I am not interested in a what brand is better than another brand. I would like to see this as a single go to post for what hardware types are out there. I will update this first post as...

I have not done that. It makes a rough noise when I spin it in the proper direction. The outside of the "can" is dinged up pretty darn bad. In fact, that motor took the brunt of the impact that busted that arm of the P3. And then, it ran upside down at wide open with that motor grinding on...